DESIGN AND FABRICATION OF A PRINTING BLOCK MACHINE

DESIGN AND FABRICATION OF A PRINTING BLOCK MACHINE

This project work titled DESIGN AND FABRICATION OF A PRINTING BLOCK MACHINE has been deemed suitable for Final Year Students/Undergradutes in the Mechanical Engineering Department. However, if you believe that this project work will be helpful to you (irrespective of your department or discipline), then go ahead and get it (Scroll down to the end of this article for an instruction on how to get this project work).

Below is a brief overview of this Project Work.

Format: MS WORD  |  Chapters: 1-5  |  Pages: 56
 
Parameters on which clear prints depends were comprehensively investigated. The study revealed that clear print depends on the impressed pressure the working temperature and the gold foil print paper life expectancy. Also studies were he manner of dependence of these parameters on prints impressed  on sheets of varied thickness. The results of these investigation were  utizlied in the design and fabrication of an operational manual printing machine using gold foil   sheet depositor clear prints were impressed on papers during the new machine’s operation.
 
CHAPTER ONE
1.1              Introduction                                                               
1.2              Literature review and data collection                        
1.3              Experimental determination of pressure for prating               
1.4               Design specification                                      
CHAPTER TWO
2.1              Design solutions                                                         
2.2              Alternative A press foot printer                                             
2.3              Alternative  B; crank arm  (handle )                          
2.4              Alternative  C; automatic (motorized) printer                       
2.5              Comparison of alternative and choice                                   
CHAPTER THREE
3.1              Design selection and analysis of parts of chosen alternative
3.2              Theory of  design/  design calculation                                   
3.3              The  design of the shaft (Hollow)                                          
CHAPTER FOUR
4.1  Construction of prototype  
4.2 General                                                                                    
4.3              Material selection                                                                   
4.4              sequence of construction and assembly                                 
CHAPTER FIVE
5.1              Testing of prototype (test – run)                                            
5.2              Evaluation of machine efficiency                              
5.3              Operator’s manual                                                                  
5.4              Costing  (cost analysis)                                                          
5.5              Problems Encounter                                                   
5.6              Conclusion                                                                             
5.7              Recommendation
References

==== The End ====

How to Download the Full Project Work for FREE

  • You can download the Full Project Work for FREE by Clicking Here.
  • On the other hand, you can make a payment of ₦5,000 and we will send the Full Project Work directly to your email address or to your Whatsapp. Clicking Here to Make Payment.

You Might Also Like